Good deals on lights

[s@ndm@n]

I'm still not running the relay after it popped. Still have a wire jumper in the relay can...

[thmTerry]

Originally Posted by sin cal hd

It goes from Batt to fuse panel to a switch then to the lights.

If the switch isnt big enough it wont put enough power to the ballast to fire both lights that why you need a relay. I know from experience.

[s@ndm@n]

Originally Posted by thmTerry

If the switch isnt big enough it wont put enough power to the ballast to fire both lights that why you need a relay. I know from experience.

...so you hear "its not big enough" a lot, do ya?

[sin cal hd]

Originally Posted by s@ndm@n

Does it try to light, and then die? That's a ballast if so. Switch it out with a know good and try again.

Comes on for about a quickie. Thats what I was thinking. My bro in law switched out and they work fine.

Originally Posted by thmTerry

If the switch isnt big enough it wont put enough power to the ballast to fire both lights that why you need a relay. I know from experience.

I have 3 switches and all the same. Only the inside light is acting wierd.

[J.T.]

Originally Posted by sin cal hd

Comes on for about a quickie. Thats what I was thinking. My bro in law switched out and they work fine.




I have 3 switches and all the same. Only the inside light is acting wierd.

Check your Zip ties Sounds like believe it or not that you may have pinched a wire

[sin cal hd]

Originally Posted by J.T.

Check your Zip ties Sounds like believe it or not that you may have pinched a wire

Sometimes when I jiggle the wire, it will work. Other times it wont. The zip ties aren't really even that tight. I'll figure it out 1 day.

[J.T.]

bad connection go through and solder your connections